Differences

This shows you the differences between two versions of the page.

--- giraffplus:home-configuration [2013-11-06 14:00] – jonas
+++ giraffplus:home-configuration [2013-11-06 14:02] (current) – jonas
@@ Line 29: / Line 29: @@
    * It might be a good idea to verify that there are no previously configured sensors on the device before doing this configuration step. If there are devices registered simply delete them in the “Radio Triggers & Events” window and “Write” the settings to the VI+.
-   * Make a note of the sensors and their location codes, i.e. 61 and 40 in the figure above, you will need this information later.3 Configuring the sensors in the GiraffPlus database
+   * Make a note of the sensors and their location codes, i.e. 61 and 40 in the figure above, you will need this information later.
+====== Configuring the sensors in the GiraffPlus database ======
    * While connected to the VPN, and with the browser certificate installed, go to: [[https://10.31.33.18/]], you should be presented with a graphical user interface.
    * Press “Home” in the “Create” section of the page, name your home to something meaningful and press “Next”. In the following screens you can select authorized organizations and primary users  etc., you can hold the CTRL key on the keyboard to select several choices at once.
-   * At the current state this choices are not important since the functionality is not fully implemented. When you get to the “Add” screen add the rooms in which you have placed sensors. When you add a new room you also need to add one or more locations to it and this has to be done before naming your room and pressing “Done”. In the locations screen you will enter a two digit code, this code needs to correspond to the location code in PCConnect.
+   * <del>At the current state this choices are not important since the functionality is not fully implemented</del>. When you get to the “Add” screen add the rooms in which you have placed sensors. When you add a new room you also need to add one or more locations to it and this has to be done before naming your room and pressing “Done”. In the locations screen you will enter a two digit code, this code needs to correspond to the location code in PCConnect.
    * The location code and the sensor type is used to distinguish between the sensors, thus you can not have two sensors of the same type at the same location.
    * The room name is not critical to the setup procedure.